Redmond AMGP Pump

The Redmond AMGP Pump is a custom designed progressing cavity type grinder pump, with check valve, tank and all necessary controls packaged into a single unit, ready to connect and designed to fit into nearly all existing grinder pump wet wells.

Discharge a finely ground slurry into small diameter pressure piping. Wear-resistant and durable stainless steel cutter wheel helps pass the material through the piping with ease.

Plastic, rubber, wood and light metal can be handled without jamming the grinder or clogging the pump.

Elimination of floats using a “Turn On” level and continued pumping until the “Turn Off” level is reached. These switches actuate when the predetermined depth is met.

Running time is short and the power consumption is low which leads to long-lasting pump life assured.

Cast Iron Housing and Motor Head with a powder-coated epoxy finish is corrosion resistant.

Motor:
1 HP, 1725 rpm, high torque, capacitor start, thermally protected, 240 or 120 volt, 60 hertz, 1 phase

Control Panel
NEMA 4X, UL-listed disconnect panel includes (2) 15 AMP Breakers (1 pole alarm, 2 pole power), push to silence alarm button, push to run button, audible and visual alarms.

Discharge Connections:
Pump Discharge terminates in 1 1/4 inch NPT female thread. Can easily be adapted to 1 1/4 inch PVC pipe or any other material required by local codes.

Discharge: *

  • 15 gpm at 0 psig
  • 11 gpm at 40 psig
  • 9 gpm at 60 psig
Overload Capacity:
Maximum pressure which pump can generate is limited by the motor. Automatic reset feature does not require manual operation following overload.

Applications
  • Residential Wastewater
  • Light Commercial
  • 1 ¼-inch slide face discharge connection is adaptable to any existing discharge piping.